+libcec (2.0.1-1) unstable; urgency=low
+
+ * changed/added:
+ * added Loewe support
+ * added signal handlers to client applications
+ * Documentation updated
+ * replaced cec-config-gui by libCEC tray
+ * log the exact data for failed transmissions, not the opcode
+ * don't log every frame, unless debugging was enabled in ./configure or
+ visual studio
+ * changed some log levels from NOTICE to DEBUG, so the non-debugging output
+ is less spammy
+ * interface changes:
+ * WARNING: breaking API changes
+ * clean up: deprecated methods and fields removed
+ * callback parameters changed to fix plain C compilation
+ * added GetAdapterProductId()+GetAdapterVendorId()/
+ cec_get_adapter_product_id()+cec_get_adapter_vendor_id()
+ * added iDoubleTapTimeoutMs to libcec_configuration
+ * remove all pre-v2.0 compatibility checks
+ * fixed:
+ * fix plain C compilation
+ * prevent sending directly addressed commands from being sent to broadcast
+ * don't wait for a response when sending a reply, so we don't block message
+ handling
+ * message response signaling and logging
+ * prevent double taps by not sending the same key press twice within 200ms
+ * fall back to the primary client when
+ CCECProcessor::HandleLogicalAddressLost() and no client could be found
+ * no more delay up to 2 seconds when exiting libCEC
+ * don't get caught in a loop in CVLCommandHandler when the source switch
+ was not allowed and no power status request was sent
+ * always send image view on to the tv, don't check the power status
+ * only respond to vendor commands for panasonic if we are the destination
+ * rpi: current firmware first sends a change to logical address 'broadcast'
+ and then signals us that the address was lost. libCEC then failed to
+ re-register, because it didn't know any client at this address
+
+ -- Pulse-Eight Packaging <packaging@pulse-eight.com> Mon, 8 Oct 2012 21:30:00 +0100
+
libcec (1.9.1-1) unstable; urgency=low
* changed/added: